Subscribe

RSS Feed (xml)

Wednesday, May 13, 2009

REM3 (Hand-Held 2-Way Remote Keypad - User Manual)


Introduction

The REM3 is a stylish wireless hand-held 2-way remote keypad. The REM3 provides independent arming / disarming in any mode
(arm, sleep, stay, or off) for two partition. It also displays the system status for both partitions with visual and audible feedback via its
two independent row of lights. Furthermore, the REM3 can display your arm status, whether you are close to home or away.


Overview
1. How to add a remote to your system - see reverse
2. How to unlock the remote - see below
3. How to view system status - see below
4. How to arm / disarm your system using arm keys - see below
5. Understanding your remote control’s feedback - see below and Remote Control Feedback on reverse
6. How to toggle PGMs (programmable outputs, such as a garage door) using PGM Keys - see below
7. How to trigger panic alarms using Combo Keys - see below
8. How to replace the battery - see reverse

REMOTE CONTROL OVER VIEW
Unlocking the Remote
  • To prevent the keys from being accidentally pressed, the remote is locked when not in use. Press & hold the Information Key [i] for one second to unlock your remote.
  • The remote will lock again after five seconds of inactivity.
  • Unlock the remote to perform any action.
Viewing Current System Status
  1. (Must be in range of your system) Press & hold the Information Key [i] for one second.
  2. Press & hold the Information Key [i] again for one second to see the current system status.
Viewing Last System Status
1. (Can be out of range of your system) Press & hold the Information Key [i] for one second.
2. The remote will then display the last system status saved by the remote.

Remote Control Feedback
The Information light displays feedback of both your system and your remote’s status. See the Remote Control Feedback table on reverse.

Arming/Disarming Your System
  1. Press & hold the Information Key [i] to unlock the remote.
  2. Press the [ARM], [SLP], [STAY] or [OFF] key for partition 1 and/or partition 2 until the
  3. beep.
  4. Enter your user code on the remote. The system is armed / disarmed.
Note: See the Remote Control Feedback table on reverse for a description of the visual and audible feedback when arming / disarming your system.

Arming/Disarming Your System Using One-Touch
  1. Press & hold the Information Key [i] to unlock the remote.
  2. Press the [ARM], [SLP], [STAY], or [OFF] key for partition 1 and/or partition 2 until the second beep. The system is armed / disarmed.
Note: One-touch arming/disarming must be set by your installer.

Using the PGM Keys
  1. Press & hold the Information Key [i] to unlock the remote.
  2. Press and hold the desired PGM key (1 to 6) for three seconds to trigger the programmed action.
  3. Enter your user code on the remote.
Note: PGM keys can be programmed so that there is no need to enter your user code. Simply unlock the remote and press and hold (3 sec.) the desired PGM key. Consult your installer for more information.

Using the Combo Keys
  1. Press & hold the Information Key [i] to unlock the remote.
  2. Press and hold both keys simultaneously.
Note: Combo keys are used to trigger an action (e.g., alert the fire department & other panic alarms) without unlocking the remote or entering a user code. Combo keys must be set by your installer.

0 comments: